Tranzeo Wireless Technologies Inc GNVPZ1NT3 Manuale Utente
Chapter 8: System Settings
TR0153 Rev. E1
60
> use sys
sys> set location.gps.latitude=”34.01”
sys> set location.gps.latitude=”34.01”
A description of the EnRoute500’s location can be stored in the ‘location.postal’ field in the
‘sys’ interface. For example, you can set the location value as shown below.
> use sys
sys> set location.postal=”Light post near 123 Main St., Anytown, CA”
sys> set location.postal=”Light post near 123 Main St., Anytown, CA”
Web GUI
The location information can be set via the web interface using the “Location” tab on the
“System Parameters” page.
“System Parameters” page.
Figure 31. Setting location and certificate information
8.12 Cluster Name
A name can be assigned to the mesh neighborhood, or cluster. This name will be displayed in
the upper right-hand corner of the web interface on all web interface pages. This name can be
used to easily identify which device or mesh neighborhood is being accessed with a particular
instance of the web interface. This name does not have any effect on the formation of the
mesh and can be different for devices in a mesh neighborhood.
the upper right-hand corner of the web interface on all web interface pages. This name can be
used to easily identify which device or mesh neighborhood is being accessed with a particular
instance of the web interface. This name does not have any effect on the formation of the
mesh and can be different for devices in a mesh neighborhood.