Honeywell International Inc. CS19A Manuale Utente

4 - 18

bar code has been encountered.  Scan the bar code below, then set the 
delay (from 1-3,000 milliseconds) by scanning digits from the inside back 
cover, then scanning Save.  

Default = 500 ms.

Scan the bar code below to set all Preferred Symbology entries to their 
default values.

When turned off, the bar code data will be output to the host as the scanner 
decodes it.  When turned on, all output data must conform to an edited 
sequence or the scanner will not transmit the output data to the host 
device.
Note: This selection is unavailable when the Multiple Symbols Selection is 

turned on.

This programming selection allows you to program the scanner to output 
data (when scanning more than one symbol) in whatever order your appli-

cation requires, regardless of the order in which the bar codes are 
scanned.  Reading the Default Sequence symbol programs the scanner to 
the Universal values, shown below.  These are the defaults.  Be certain 
you want to delete or clear all formats before you read the Default 
Sequence

 symbol.

Note: You must hold the trigger while reading each bar code in a sequence.

Note: To make Output Sequence Editor selections, you’ll need to know the 

code I.D., code length, and character match(es) your application 

requires.  Use the Alphanumeric symbols (inside back cover) to read 

these options.

Preliminary Draft