Honeywell International Inc. CS19A Manuale Utente

4 - 22

When an output sequence is Required, all output data must conform to an 
edited sequence or the scanner will not transmit the output data to the host 
device.  When it’s On/Not Required, the scanner will attempt to get the 
output data to conform to an edited sequence but, if it cannot, the scanner 
transmits all output data to the host device as is.

When the output sequence is Off, the bar code data is output to the host as 
the scanner decodes it. 

 Default = Off. 

Note: This selection is unavailable when the Multiple Symbols Selection is 

turned on.

When this programming selection is turned On, it allows you to read multiple 
symbols with a single pull of the scanner’s trigger.  If you press and hold the trig-
ger, aiming the scanner at a series of symbols, it  reads unique symbols once, 
beeping (if turned on) for each read.  The scanner attempts to find and decode 

new symbols as long as the trigger is pulled.  When this programming selection 
is turned Off, the scanner will only read the symbol closest to the aiming beam.  

Default = Off.

Preliminary Draft