Honeywell International Inc. CS19A Manuale Utente

1 - 10

When you have entered all the commands you want to save for your custom 
defaults, scan the Save Custom Defaults bar code.

Note: If using a cordless system, scanning the Save Defaults bar code also 

causes both the scanner and the base to perform a reset and become 

unlinked.  The scanner must be placed in its base to re-establish the link 

before any setup codes are entered.  See 

You may have a series of custom settings and want to correct a single setting.  

To do so, just scan the new setting to overwrite the old one.  For example, if you 
had previously saved the setting for Beeper Volume at Low to your custom 
defaults, and decide you want ithe beeper volume set to High, just scan the Set 
Custom Defaults

 bar code, then scan the Beeper Volume High menu code, 

and then Save Custom Defaults.  The rest of the custom defaults will remain, 
but the beeper volume settiing will be updated.

If you want the custom default settings restored to your scanner, scan the Cus-
tom Product Default Settings

 bar code below.  This resets the scanner to the 

custom defaults.  If there are no custom defaults, it will reset the scanner to the 
factory defaults.  Any settings that have not been specified through the custom 
defaults will be defaulted to the factory default settings.

Note: If using a cordless system, scanning this bar code also causes both the 

scanner and the base to perform a reset and become unlinked.  The 

scanner must be placed in its base to re-establish the link.  See 

beginning on page 3-1 for additional information.

Preliminary Draft