Honeywell International Inc. CS19A Manuale Utente

2 - 24

The unit stays awake to receive data until the RS232 Receiver Time-Out 
expires.  A manual or serial trigger resets the time-out.  When an RS232 

receiver is sleeping, a character may be sent to wake up the receiver and reset 
the time-out.  A transaction on the CTS line will also wake up the receiver.  The 
receiver takes 300 milliseconds to completely come up.  Change the RS232 
receiver time-out by scanning the bar code below, then scanning digits  from the 
inside back cover of this manual, then scanning Save. The range is 0 to 300 

seconds.   

Default = 0 seconds (no time-out - always on).

RS232 Handshaking allows control of data transmission from the scanner using 
software commands from the host device.    When RTS/CTS is turned Off, no 
data flow control is used.  

  The scanner asserts RTS when it has data to 

send, and will wait indefinitely for CTS to be asserted by the host.

  The scanner asserts RTS when it is OK for the 

host to transmit.  The host asserts CTS when it is OK for the device to transmit.

  The scanner asserts RTS when it has data to 

send and waits for a delay (see 

 on page 2-25) for CTS to be 

asserted by the host.  If the delay time expires and CTS is not asserted, the 
device transmit buffer is cleared and scanning may resume.  

Default = RTS/CTS Off.

Preliminary Draft