Honeywell International Inc. CS19A Manuale Utente

3 - 15

 stores bar code data, whether or not you are in range of 

the base.  To transmit the stored data to the base, either place the scanner in 
the base, or scan 

 (page 3-19).  When the scanner’s 

buffer space is full, any bar codes scanned generate an error tone.  In order to 
scan bar codes again, the data must be transmitted to the base. 
Default = Batch Mode Off.

Scan Batch Mode Beep On to program the scanner to beep when it enters 
Batch Mode.  

Default = Batch Mode Beep On.

When a scanner is storing data during a Batch Mode process, you can 
select whether the data is stored in Flash memory or in RAM.  

 The scanner writes any untransmitted data to flash mem-

ory prior to powering down.  The data will still be there when the scanner 
powers back up.  However, the scanner will power down, even with untrans-
mitted data, if it reaches a power down timeout or if the battery power is 
very low. 

Preliminary Draft