Honeywell International Inc. SF61B-A Manuale Utente

will do so with an HID connection or a scanner-initiated Incoming 
SPP connection for example).

A software reset of your scanner will reset its parameter settings to 
their initial values so you will have to reconfigure any custom settings 
you have programmed in your scanner (see Chapter 3, 

Turn the scanner on by pressing the trigger one time, then release.

Press and hold the scan button for 30 seconds until the red LED 
comes on.

The scanner will beep after 20 seconds (hardware reset) however, 
keep the trigger pressed until the red LED comes on (10 more 
seconds after the hardware reset).

Press the scan button very rapidly five times in succession while 
the red LED is on (you need to be quick as the red LED only stays 
on for 2 seconds).

The green LED comes on, the scanner beeps a reset confirmation 
(six-beep melody) and powers off and powers on (two beeps and 
vibrate alert by default).

If you had a Bluetooth connection before the software reset, the 
SF61B will disconnect from the host device.

Note: You may not be able to tell if the scanner is on, for example if 
the LEDs have been disabled and do not light up when you pull the 
trigger. 

Note: Depending on your host configuration (device, Bluetooth 
version), after a software reset of your scanner (Reset factory defaults) 
you may have to re-pair your product with your host device /
application (see the appropriate section in Chapter 2, 

).