Honeywell International Inc. SF61B-A Manuale Utente

If your SF61B appears “dead” or does not respond when you press the 
scan button, you can try to:

restart the product (hardware reset)

reset the product’s configuration settings to their initial values 
(software reset)

A hardware reset does not lose the current configuration settings.

A software reset sets all the configuration settings of the scanner back 
to their default values, including custom default settings (same effect 
as when you read the 

Reset factory defaults configuration bar code).

A hardware reset will restart your scanner, keeping the current 
configuration. 

Turn the scanner on by pressing the trigger one time, then release.

Press and hold the scan button for more than 20 seconds until the 
scanner beeps twice and vibrates (no red LED).

Release the scan button.

If you have a Bluetooth connection, the SF61B disconnects from 
the host device when it switches off. 

After a restart, your scanner may try to reestablish the Bluetooth 
connection with the host depending on the type of connection (it 

Note: If your scanner does not turn on after a hardware and/or 
software reset and you are using a correctly charged and functioning 
Intermec battery pack Model 1016AB01 (P/N SF61-BAT-xxx,), please 
contact your Intermec representative.

Note: You may not be able to tell if the scanner is on, for example if 
the LEDs have been disabled and do not light up when you pull the 
trigger.