Honeywell International Inc. 7850LPE Manuale Utente
8 - 5
Powering the Dolphin HomeBase
The terminal requires 9.5 volts DC input for communication and battery charging; the power adapter on the power cable converts
the voltage from the power source to 9.5 volts DC. Only power adapter cables from Hand Held Products convert the voltage
appropriately.
the voltage from the power source to 9.5 volts DC. Only power adapter cables from Hand Held Products convert the voltage
appropriately.
1. Plug the power cable into the power adapter.
2. Plug the power cable into the power source.
3. Plug the connector cable into the DC power jack on the back panel. The Dolphin HomeBase is now powered.
When a terminal is properly seated in the terminal well, the Dolphin HomeBase powers the terminal, charges the terminal’s main
battery pack, and launches ActiveSync communication (see
battery pack, and launches ActiveSync communication (see
Hand Held Products recommends that you leave the Dolphin HomeBase connected to its power source at all times, so that it is
always ready to use.
always ready to use.
RS-232 Serial Connector
The following diagram displays the pins of the RS-232 serial connector of the
Note: Signals referenced are for a DTE device. The HomeBase is at a right-angle to the printed circuit board (PCB). The ninth
pin has a ring indicator (RI).
Plug this connector into the
panel.
Power Adapter
Power Cable
3LQ
'HVFULSWLRQ
,QWHUQDO -XPSHU WR 3LQ
7;'
5;'
'65
*1'
'75
&76
576
5,