Honeywell International Inc. MX2702 Manuale Utente

The IT2020 uses TTL signal levels to wedge into an RS-232 serial network.  Use 
only IT2020 serial wedge cables to prevent damage to the base.  Refer to 

and communications protocol.

1. Turn off power to the computer.

2. Disconnect the existing serial cable from the computer.

3. Connect the appropriate interface cable to the base.

Note: For the base to work properly, you must have the correct cable for your 

type of computer.

4. Plug the serial connector into the serial port on your computer.  Tighten the 

two screws to secure the connector to the port.

5. Plug the other serial connector into the other device connection and tighten 

the two screws.

6. Plug the power supply barrel connector to the base, and plug the power 

supply into the AC source.

7. Once the base has been fully connected, power up the computer.

6

4

5

Other device