COOPER INDUSTRIES INC FH1848D Manuale Utente
17
$
$
"
E-Stop Test
Press E-STOP Button
$
$
#
E-Stop Test Part two
Release E-STOP Button
N/A
"
"
Functions not all off on
EMERGENCY STOP
release
EMERGENCY STOP
release
Set all functions off
N/A
!
$
All Okay, all functions off
OK, continue as required
N/A
"
$
All Okay, 1+ functions on
OK, continue as required
N/A
$/"
!
Emergency Stop
E-STOP Button Pressed
"
N/A
N/A
Low Battery
Replace/Recharge Battery
"
"
#
Module failure: Joystick
Cycle Power--if not remedied, call
service
service
"
#
"
Module failure: Radio
Cycle Power--if not remedied, call
service
service
7.2.7. Numeric Display
The transmitter contains a three-digit numeric display to further indicate operating
status. It can display numbers between 0.0 and 99.9, and is lighted for night viewing.
There are several quantities that the display can show, indicated by “pointers” to three
marks (LOAD %, BOOM ANGLE, DIAG) at the right edge of the display:
There are several quantities that the display can show, indicated by “pointers” to three
marks (LOAD %, BOOM ANGLE, DIAG) at the right edge of the display:
Mark Pointed To
Quantity Shown
LOAD %
Percentage of allowable boom load.
BOOM ANGLE
The absolute value of the boom angle, in degrees.
DIAG
The voltage, 0.0 to 5.0, at the piston-side pressure sensor.
BOOM ANGLE and
DIAG2
DIAG2
The voltage, 0.0 to 5.0, at the rod-side pressure sensor.
(none)
This special mode shows the Boom Derating Factor being
adjusted and will only appear in Factory Setup mode. Please
see 9. Factory Parameters for more information.
adjusted and will only appear in Factory Setup mode. Please
see 9. Factory Parameters for more information.
To change between these displays, press the DISPLAY button. The display will
always start at LOAD % after releasing the transmitter’s EMERGENCY STOP.
The display will only work when the transmitter is switched on and its
EMERGENCY STOP is released (the
STO P
light must not be on or flashing); otherwise, the
display will show three dashes (“- - -”) in place of numbers. If the T47 Cable Remote is
plugged in and switched on, the display on the T45 Transmitter will stop working and the
information will be displayed on the T47’s display instead.
plugged in and switched on, the display on the T45 Transmitter will stop working and the
information will be displayed on the T47’s display instead.
The display in the T45 will operate within a 100-foot (approximate) radius of the
Receiver/Controller’s antenna; however, the remote control of the machine will operate
much farther. Should the display stop working because you are too far from the machine,
you can still safely operate the controls but you will not be able to read the status
information.
much farther. Should the display stop working because you are too far from the machine,
you can still safely operate the controls but you will not be able to read the status
information.