Applied Concepts Inc ACMI006 Manuale Utente
4
REAR:
The REAR icon indicates the rear antenna is selected for use. The icon will light with
a steady indication if the antenna is operational or a blinking indication if the antenna is
missing or inoperative.
a steady indication if the antenna is operational or a blinking indication if the antenna is
missing or inoperative.
SLOW:
The SLOW icon indicates that the radar is in slow target same lane mode. Conversely,
fast target same lane mode is indicated by the absence of the SLOW icon. See SAME
LANE THEORY, page 14.
fast target same lane mode is indicated by the absence of the SLOW icon. See SAME
LANE THEORY, page 14.
SAME:
The SAME icon indicates that the radar is in same lane mode. Conversely, opposite
lane mode is indicated by the absence of the SAME icon. See SAME LANE
THEORY, page 14.
lane mode is indicated by the absence of the SAME icon. See SAME LANE
THEORY, page 14.
LOCK:
The LOCK icon indicates that the operator has locked a target speed in the center
window.
window.
Audible Indicators
Antenna tones
- Different audio tones are used when switching between the front and the rear antenna. A 1-beep tone
corresponds to the front antenna, while a 2-beep tone corresponds to the rear antenna.
Faster tone
- Different audio tones are used when turning the faster mode on and off. A high-pitched beep tone (for
fast) indicates that faster mode is selected. A normal beep tone indicates that faster mode is turned off.
Self-Test tones
- A 4-beep “happy” tone indicates the successful completion of a self-test operation. A 15-beep tone
indicates a failed self-test.
Automatic Self-Test
- An automatic self-test (indicated by a 4-beep “happy” tone) is performed every 15 minutes while
S
PATROL
is transmitting.
NOTE: If for any reason “FAIL” comes up on your S
PATROL
Radar, the unit must be turned OFF and then back
ON to reset the FAIL mode. As an example, if you did not properly attach the antenna cable and the word “FAIL”
appeared, it would be necessary to correct this problem, to properly connect the cable, then turn the power OFF and then
back ON. The word FAIL should not reappear.
appeared, it would be necessary to correct this problem, to properly connect the cable, then turn the power OFF and then
back ON. The word FAIL should not reappear.