FLIR Commercial Systems Inc. RT30 Manuale Utente

  

™ Engineering Design Specification

 

 

Page 12 of 20

                  

The working address for all RT30 devices shall be 45583730

h

 (‘EX30’ ASCII). 

 
 

While the RT30 shall accept all commands defined in the Inter-Module RF Communications specification without 
system failure, the TU shall only send, and the RU shall only act upon, the following commands: 
 

• Alarm 

Status 

• Hello 

• Beep 

Code 

• Comm 

Channel 

Change 

 
 
5.3 S

This switch has three positions: 
 

•  Off – The unit is off, and battery power is completely disabled. 
•  NCV – The internal NCV circuit is enabled.  This setting can be overridden by attaching the External 

Probe. 

•  Light – The LDR circuit is enabled.  This setting can also be overridden by attaching the External 

Probe. 

 
 

This switch is a momentary switch.  It has two functions: 
 

•  Calibrate – If the switch is pressed for more than 100mS, but less than 5 seconds, the RT30 shall enter 

Calibrate Mode.  A ‘short’ press is also used to select channels. 

•  Channel  – If the switch is pressed for more than 10 seconds, the RT30 shall enter Channel Select 

mode. 

 
 

This switch has three positions: 
 

•  Off – The unit is off, and battery power is completely disabled. 
•  On – The receiver is on, and the Beeper is enabled. 
•  Silent – The receiver is on, but the Beeper is disabled from announcing alarm conditions.  Beep codes 

for auxiliary functions shall still be sent.