Deister Electronic GmbH UDL500 Manuale Utente
2.4 UDL500: Control digital output via hardware trigger
Installation notes: We recommend professional grounding of the device (see 2.1
Installation note). Output OUT and Input IN are potential-free. Take care that the
grounding will be sufficient (use second tab connector)!
Installation note). Output OUT and Input IN are potential-free. Take care that the
grounding will be sufficient (use second tab connector)!
The potential-free input IN may be used to control the reader by a hardware trigger (e.g.
tip switch). The control of the potential-free output OUT can be configured within the
software. For this the reader has to be operated in trigger mode.
tip switch). The control of the potential-free output OUT can be configured within the
software. For this the reader has to be operated in trigger mode.
In the following example of circuits, the output OUT has not been potential isolated:
UDL500 housing
V17/01/08
deister electronic GmbH 30890 Barsinghausen Germany
7
Wiring & Installation Instructions UDL500