HID Global Corporation 0006A Manuale Utente

_____________________________________________________________________________________________________
HID Corporation  9292 Jeronimo Road   Irvine, CA 92618-1905 USA TEL (949) 598-1600  (800) 237-7769  FAX (949) 598-1690
Web page, E-mail - www.hidcorp.com - ProxPoint Installation Manual 6005-910 Rev A

               2 of 2

- ProxPoint

TM

 Reader with snap-on cover and 18” cable

1

- #4-24 x 1” self-tapping flathead screw

2

- Installation manual

1

- Wire splice

9

- DC Power supply 5.0 VDC or 12 VDC

2

•

  Determine an appropriate mounting location. The

reader may be mounted to any surface, including
metal.

•

  Drill two (2) 5/64-inch (2mm) holes approximately 1

inch deep for mounting the reader.

•

  Drill a 5/8-inch (16mm) hole for the cable.

•

  Remove the snap-on cover from the reader and

secure the reader to the mounting surface.

•

  Route the cable from the reader and/or power

supply to the host. A linear type power supply is
recommended. Check all electrical codes for proper
cable installation.

•

  Test the operation of the reader. After completion of

the test, replace the snap-on cover.

Connect the reader to the host according to the wiring
table below and the host installation guide.

Wiegand

Clock & Data

Wire Color

+DC
+DC

Red

Ground
Ground

Black

---

Card Present

Violet

Data0

Data

Green

Data1

Clock
White

Shield Ground
Shield Ground

Drain

Green LED
Green LED

Orange

Red LED
Red LED

Brown

Beeper
Beeper

Yellow

Hold
Hold

Blue