HID Global Corporation 4045 Manuale Utente
ENTRYPROX – 4045-907 REV A
10
2. Remove the main circuit board by pushing outward
on the two spring tabs in the direction shown in
Figure 4.
3. Lift the main circuit board.
4. Unplug the four-pin cable assembly from
connector P4 on the main circuit board.
5. Release the antenna housing from the controller
keypad by pressing inward on the four securing tabs.
6. Remove the antenna housing from the controller
keypad by pushing forward as shown in Figure 6.
7. Insert the extra 10-inch antenna cable assembly
into connector P4.
8. Splice in additional antenna cable Alpha 1174C
(22AWG) up to a maximum of 10 feet.
on the two spring tabs in the direction shown in
Figure 4.
3. Lift the main circuit board.
4. Unplug the four-pin cable assembly from
connector P4 on the main circuit board.
5. Release the antenna housing from the controller
keypad by pressing inward on the four securing tabs.
6. Remove the antenna housing from the controller
keypad by pushing forward as shown in Figure 6.
7. Insert the extra 10-inch antenna cable assembly
into connector P4.
8. Splice in additional antenna cable Alpha 1174C
(22AWG) up to a maximum of 10 feet.
9. Make the wiring connections for the Request to
Exit switch, the door locking devices, the power
supply, and the alarm inputs and outputs.
Exit switch, the door locking devices, the power
supply, and the alarm inputs and outputs.
Refer to the
“Wiring EntryProx” section for appropriate wiring
diagrams and instructions.
diagrams and instructions.
10. Reattach the main circuit board to the controller
keypad unit.
11. Insert the blank filler piece into the controller
keypad unit.
12. Attach the controller keypad unit to the mounted
backplate and secure the EntryProx unit with a hex
screw or tamper screw.
13. Run the additional antenna cable to the antenna
housing location.
14. Mount and wire the antenna housing
keypad unit.
11. Insert the blank filler piece into the controller
keypad unit.
12. Attach the controller keypad unit to the mounted
backplate and secure the EntryProx unit with a hex
screw or tamper screw.
13. Run the additional antenna cable to the antenna
housing location.
14. Mount and wire the antenna housing
Note: The Alpha 1174C antenna cable is not supplied with the
EntryProx unit.
EntryProx unit.