Справочник Пользователя для HID Global Corporation 4045

 

ENTRYPROX – 4045-907  REV A 

10 

2. Remove the main circuit board by pushing outward 
on the two spring tabs in the direction shown in 
Figure 4. 
3. Lift the main circuit board. 
4. Unplug the four-pin cable assembly from 
connector P4 on the main circuit board. 
5. Release the antenna housing from the controller 
keypad by pressing inward on the four securing tabs. 
6. Remove the antenna housing from the controller 
keypad by pushing forward as shown in Figure 6. 
7. Insert the extra 10-inch antenna cable assembly 
into connector P4. 
8. Splice in additional antenna cable Alpha 1174C 
(22AWG) up to a maximum of 10 feet. 

 

9. Make the wiring connections for the Request to 
Exit switch, the door locking devices, the power 
supply, and the alarm inputs and outputs. 

Refer to the 

“Wiring EntryProx” section for appropriate wiring 
diagrams and instructions. 

10. Reattach the main circuit board to the controller 
keypad unit. 
11. Insert the blank filler piece into the controller 
keypad unit. 
12. Attach the controller keypad unit to the mounted 
backplate and secure the EntryProx unit with a hex 
screw or tamper screw. 
13. Run the additional antenna cable to the antenna 
housing location. 
14. Mount and wire the antenna housing