HID Global Corporation 6042AA Manuale Utente

_________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690
Web page –

www.proxtrak.com

– ProxTrak Portal Reader Installation Procedure 6042-901-01 Rev 7

17 of 32

7. Tables – Switch settings, EEPROM Settings and Indicator actions

Switch Settings - Caution: Power must be off and Static protection must be used when changing these
switches.

7.1 Acquisition Processor switches

Note: In general the acquisition switches are factory and troubleshooting settings only – the Main
configuration changes are done on the Communication section Switches – Switch 6, 7, 8 and 9, shown
below.
Switch 2 – Acquisition testing
1. De-multiplexed data capture Channel (Receiver) 1
2. De-multiplexed data capture

Channel (Receiver) 2

3. De-multiplexed data capture

Channel (Receiver) 3

4. De-multiplexed data capture

Channel (Receiver) 4

5. Header capture

If On, F/W allows Header from strongest channel to be at 0x80008000

6. ID Capture

If On, F/W allows next ID from the strongest channel to be at 0x80008000

7. Skip auto-null

If On, skips auto-null at power-up

8. Spare

Not

used

Switch 3 – Acquisition testing (continued)
1. Miller

code generator

If On, generates a Miller coded tag number for de-bugging purposes

2. Checksum validation

If On, Reader requires a checksum for validating Asset tags

3. A/D loop-back

If On, Reader generates an data stream for the digital filtering algorithms

4. Disable Dynamic Auto-null

If On, Disables the dynamic auto-null

5. Run Mode

If On, Forces CP Run mode ("RN" on LED's)

6. Programming mode

If On, no programming on power-up, normal operating mode ("FL") on

LED's

7. Skip FSK Reader

Along with switch 8 (Lsbit), it is the number of cycles skipped for the FSK mode

After a successful Access read.

8. Skip FSK Reader

Along with switch 7 (Msbit), it is the number of cycles skipped for the FSK

mode, after a successful Access read.

Switch 4 – Acquisition testing (continued)
1. Force I phase

If On, Acquisition is always on I phase

2. Force Q phase

If On, Acquisition is always on Q phase

3. 180 degree phase shift

If On, data is shifted 180 degrees

4. Daughter board type