HID Global Corporation X001900 Manuale Utente

Pagina di 193
© 2012 HID Global Corporation.  All rights reserved. 
 
140 
HDP8500 Industrial Card Printer/Encoder  User Guide     L001617 rev 1.1 
 
 
Warming Time Delay 
 
The setting adjusts how much additional time (in minutes) the printer will wait after the 
transfer roller reaches temperature before beginning transfer. It has a range of 0 to 20. 
 
Power On Ribbon Film Skip 
 
This setting enables power up ribbon/film savings. When enabled the ribbon and film will 
not skip to a new set of panels after a power up. Cover open/close behavior is unaffected, so 
upon a cover close the ribbon and film will skip a set of panels.. 0 
– disabled/1- enabled. 
 
Flipper Reject Angle 
    This setting adjusts the flipper angle when trying to place a card in the reject hopper. It has a 
range of +/-20. This setting should not be needed. 
 
Input Hopper Home Offset 
 
This setting adjus
ts the position of the shuttle when it‟s in the home position. It has a 
range of 0 to 30. The larger then number the closer to the front of the printer the shuttle will be 
placed. The printer must be rebooted for this setting to take effect. 
  
Input Hopper Mag Offset 
 
This setting adjusts the position of the shuttle when it‟s in the mag position. It has a 
range of -20 to 20. The larger then number the closer to the front of the printer the shuttle will be 
placed. The printer must be rebooted for this setting to take effect. 
 
Transfer Image Length 
 
This setting adjusts the length of the image on the card during transfer. It has a range of 
-10 to +10. The larger the number, the longer the image. 
Transfer Cooling Delay 
 
This setting adjusts the delay (in seconds) before transferring the second side of the 
card. It has a range of 0 to 180. The larger the number, the longer the delay in seconds..