EMS Technologies Canada Ltd. HSD-400 Manuale Utente
Page 2–15
25 June 2008
EMS SATCOM
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-400 High-speed Data Terminal
When the “reset” or “restart” is completed, the configuration values and parameters are
activated.
activated.
J. Verifying Configurations
This section describes how to view the HSD-400 terminal configuration parameters.
To view the HSD-400 terminal ORT system configuration:
1. In Menu 3, press O.
The List ORT appears.
2. Press O to scroll through the listing.
To view the new system configurations select “List EEPROM” from Menu 3:
3. In Menu 3, press L.
The List EEPROM appears.
4. Press L to scroll through the listing.
3.
Using Terminals
This section describes how to place voice and fax calls using the ISDN interface of the
HSD-400 terminal, and how to use the MPDS and Mobile ISDN data connections.
HSD-400 terminal, and how to use the MPDS and Mobile ISDN data connections.
A. Placing Swift64 Voice and Fax Calls
Placing voice and fax calls using the HSD-400 terminal is similar to placing an international
telephone call or entering a telephone number for dial-up networking data calls. Like
international telephone numbers, the HSD-400 terminal “dialing-number-sequence”
includes different routing components or codes. Figure 2-2 illustrates the required order
of the dialing components.
telephone call or entering a telephone number for dial-up networking data calls. Like
international telephone numbers, the HSD-400 terminal “dialing-number-sequence”
includes different routing components or codes. Figure 2-2 illustrates the required order
of the dialing components.
Figure 2-2. Dialing-Sequence Components