B+B SmartWorx THINQ1 Manuale Utente
Introduction
Quatech SDS User’s Manual
Identifying parts
Figures 1 and 2 show the parts of the SDS. See below for a description
of each part.
of each part.
Figure 1 shows the front view
of the SDS.
Figure 1 - SDS front view
(1) Power LED
(2) Serial ports
Figure 2 - SDS back view
1. The SDS has five indicator LEDs:
¾
Power (blue) – indicates when the SDS has line power
¾
Data (red/green) – indicates serial port data activity by blinking red for RS-232 or green for RS-422/485; QSE-/ESE-100s
have a single red Data LED that indicates any serial port activity by blinking
¾
Status (green) – indicates when the embedded processor is up and running
¾
Link (green) – indicates when a network link has been established; located on left side of Ethernet connector in RS-
232/422/485 units; QSE-/ESE-100s also have a separate Link LED
¾
Speed (amber) – differentiates between 100Base-T (glowing) and 10Base-T (off) Ethernet connection speeds; located on
right side of Ethernet connector in RS-232/422/485 units; QSE/ESE-100s also have a separate green Speed LED
2. The DB-9 serial port(s) connect to your serial device(s) and can support RS-232, RS-422, or RS-485 connections. They
are located either to the left, to either side of the Ethernet port, or on the front panel, depending on the model.
3. The RJ-45 Ethernet port connects the SDS to the Internet or to your Intranet. It has two small status LEDs: Link on the
left and Speed on the right.
4. The power jack should be connected to a +5V power source, provided with the SDS.
5. The Reset button puts the SDS through a reset cycle and can also restore the SDS to the factory default settings. The
5. The Reset button puts the SDS through a reset cycle and can also restore the SDS to the factory default settings. The
QSE-100 and ESE-100 use a Default button to restore factory default settings.
6. The information label (not shown) is on the bottom of the SDS. It includes the following:
¾
MAC address
¾
Serial number
¾
Certifications
¾
Pinout diagram
(4) Power jack
(3) Ethernet port
Figure 2 shows the rear view of
the SDS. The actual number
and location of serial ports
will vary according to the
will vary according to the
model.
(1)
Link LED
Speed LED
Speed LED
(2) Serial ports
(1) Status LED
(5) Reset button
(4) Power jack
(1)
Power LED
Power LED
Link LED
Speed LED
Data LED
Speed LED
Data LED
(1) Data LEDs
(5) Reset button
(1) Status LED
(3) Ethernet port
(5) Default button
Page 8
940-0183-151
March 2005