Manualsbrain.com
  1. Manuali
  2. Marche
  3. Scully Signal Company
  4. SENSOR
  5. Manuale Utente

Scully Signal Company SENSOR Manuale Utente

Scarica
Pagina di 4
Procedure:
1.  Ensure Base Unit has already been installed to receive transmission.
2.  With mounting rings facing left, and hinge on Scul-Com
® sensor up, slide rings
over sight glass till bottom ring rests snugly on sight glass collar.
3.  Open Scul-Com
® Sensor Cover.
4.  Following the polarity diagrams (match the battery + and – to those on the
board), press batteries into battery holders.
5.  With mounting rings facing left, and hinge on Scul-Com
® sensor up, slide rings
over sight glass until bottom ring rests snugly on site glass collar.
6.  Press reset button and ensure that the red LED flashes brightly one time. 
7.  Close cover.
8.  An LED will flash for 5 minutes on the base unit. Green flashing indicates a 
successful call to Autoreorder, red flashing indicates an unsuccessful call to
Autoreorder.
    Figure 2:  Transmitter reorder point.