Honeywell International Inc. 8DL5818MN Manuale Utente
BATTERY INSTALLATION/REPLACEMENT
1. Remove the transmitter’s end cap by inserting
the flat blade of a screwdriver in the cap’s slot and
turning slightly counterclockwise.
turning slightly counterclockwise.
2. Slide the transmitter PCB assembly out of its
case,
taking care not to bend the antenna during
this step or later.
3. Remove the old battery, if replacing it.
4. Observe correct polarity and insert the fresh
battery into the battery holder (position the battery
as shown in Figure 2).
as shown in Figure 2).
5. Slide the PCB assembly back into its case,
battery end first (
the reed switch end must be close
to the end cap).
6. Replace the end cap. Line up the projections on
the cap with the openings at the edge of the case.
Press the cap gently against the PCB and turn the
cap (via its slot) slightly clockwise, thereby locking
it in place.
Press the cap gently against the PCB and turn the
cap (via its slot) slightly clockwise, thereby locking
it in place.
SPECIFICATIONS
Dimensions:
Dimensions:
.....................
3.0” H x 0.66” W x 0.8” D
(76.2mm) x (14.0mm) x (20.3mm)
Gap (xmtr to magnet): .................
0.5” (12.7mm) max
Operating temperature: .
0 - 50º C, non-condensing
Battery:
.........................
1.5VDC, AAA Lithium
(Energizer L92) or AAA
Alkaline (Duracell MX2400,
Panasonic AM-4PI, Eveready
Energizer EN92)
(Energizer L92) or AAA
Alkaline (Duracell MX2400,
Panasonic AM-4PI, Eveready
Energizer EN92)
BATTERY CAUTION: Risk of fire, explosion
and burns. Do not recharge, disassemble, heat
above 212° F (100° C) or incinerate. Dispose of
used batteries properly. Keep away from
children.
and burns. Do not recharge, disassemble, heat
above 212° F (100° C) or incinerate. Dispose of
used batteries properly. Keep away from
children.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules, RSS210 of IC. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2), this device must accept any
interference received, including interference that may cause undesired operation.
Unauthorized changes or modifications could void the user's authority to operate the equipment.
two conditions: (1) This device may not cause harmful interference, and (2), this device must accept any
interference received, including interference that may cause undesired operation.
Unauthorized changes or modifications could void the user's authority to operate the equipment.
Note: For UL certified installations, this product is Listed for Residential use only.
For the latest warranty information, please go to:
http://www.security.honeywell.com/hsc/resources/wa/index.html
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
Copyright
2008 Honeywell International Inc.
www.security.honeywell.com
ÊK9485V1mŠ
K9485V1 10/05 Rev. B