PRÜFTECHNIK Condition Monitoring GmbH VCRFBR24 Manuale Utente
45
VIBCONNECT RF 05.2012
Installation and commissioning
5.4.4 Connecting sensor unit
Note
The sensor cables must only be connected to the sensor unit after
the sensors have been installed, so that you have the option to
extend or shorten the cables if required (see also '5.5 Installation
of sensors', page 47).
The sensor cables must only be connected to the sensor unit after
the sensors have been installed, so that you have the option to
extend or shorten the cables if required (see also '5.5 Installation
of sensors', page 47).
• Open the sensor unit and feed the sensor cable through the
cable gland provided.
• Connect the four tinned cable strands to the respective terminals
Note
Each sensor can measure two channels. The assignment of
Each sensor can measure two channels. The assignment of
the channels to the terminals is pre-configured as shown in the
diagram below.
diagram below.
Sensor 1 (left) is assigned
to channels 1 and 3.
Sensor 2 (right) is as-
signed to channels 2
and 4.
to channels 1 and 3.
Sensor 2 (right) is as-
signed to channels 2
and 4.
Terminal
CHANNEL
Function
Sensor 1
1
--
Power supply
2
1
Vibration
3
3
Temperature
4
--
GND
Sensor 2
13
--
Power supply
14
2
Vibration
15
4
Temperature
16
--
GND
Sensor 1
Sensor 2