Toshiba Client Solutions CO. LTD. UPP350WL2 Manuale Utente

network.  This password is encrypted 

using the same encryption type as the 

encryption keys. 

 
To define static encryption keys, click the Define Static Encryption Keys button with either Dynamic 
Security or Static Keys selected.  Fill in the security dialog box.   
 

In the Atheros Client Utility,  access the Advanced tab by clicking New or Modify on the Station 
Configuration tab, then clicking the Advanced tab.   
Edit the fields in the Advanced tab of the Network Configuration Settings to configure the configuration 
profile.   
Make sure to also edit the General and Security tabs. 
Field Name 

Description 

Wireless Address 

Wireless Address Specify the wireless card 

address in hexadecimal (0-9, A-F). 

Scan Mode 

Specify passive or auto scans.  The scan 

mode is set by the country code, with most 

regions using an active scan mode. 

Passive mode sets the wireless card to 

listen-only mode.  To override an active 

setting, click passive. 

802.11b Preamble 

Specifies the preamble setting in 802.11b.  

The default setting is Short & Long, which 

allows both short and long headers in the 

802.11b frames.  Set to Long Only to 

override allowing short frames. 

Wireless Mode 

Specifies 5GHz 54 Mbps, 5 GHz 108 Mbps, 

or 2.4 GHz 11 Mbps operation in an access 

point network. 

Wireless Mode when Starting   

Ad Hoc Network 

Specifies 5GHz 54 Mbps, 5 GHz 108 Mbps, 

2.4 GHz 11 Mbps to start an ad hoc 

network if no matching network name is 

found after scanning all available modes. 

QoS 

Disables or enables the station to 

cooperate in a network using Quality of 

Service. 

Transmit Power Level 

Selects full, half, quarter, eighth, or lowest 

transmit power. 

 
 

To configure a profile in ad hoc mode, change the Network Type in the General tab. This table provides the 
General tab field descriptions to configure a profile for ad hoc mode:   
Field Name 

Description 

Configuration Name 

Identifies the configuration. This name 

must be unique. Configuration names are 

not case sensitive. 

Network Name 

A network name is mandatory for ad hoc 

mode. The SSID for all stations in a single 

ad hoc network must be the same. 

Network Type 

Ad hoc. 

Power Save Mode 

Power saving mode is currently not 

supported in ad hoc mode. 

Make sure to also edit the Security and Advanced tabs.