Toshiba Client Solutions CO. LTD. UPP350WL2 Manuale Utente

In Access Point (infrastructure) mode, the Wireless Network Adapter participates in a basic service set 
(BSS) as a station, and communicates with the other stations through an AP, as illustrated here. 

To connect to an Access Point network, configure the profile for Access Point mode. 
 

1.  To remove a configuration profile, select the profile to remove from the list of configuration profiles on 

the Station Configuration tab. 

2.  Click the Remove button. 
3.  Click Apply to complete the configuration profile deletion.   
 

Configure the TCP/IP Address for the network device after configuring the Atheros AR5001X Mini PCI 
Wireless Network Adapter properties. 
 
1.  Open the Control Panel and click Network and Dial-up Connections. 
2.  Find the Local Area Connection associated with the  Atheros AR5001X Mini PCI Wireless Network 

Adapter. Right-click that connection, and click Properties. 

3.  Select Internet Protocol (TCP/IP) and click Properties. 
4.  Click the radio button Use the following IP address, then enter an IP address and Subnet mask. 

Assigning an  IP address and Subnet mask allows stations to operate in Access Point mode 
(infrastructure mode) and to have Internet access. Default gateway and DNS server information is 
also required.   

5.  IP configuration information (DHCP or assigned IP address, gateway and DNS server IP addresses) is 

usually obtained from the corporate IT staff. 

6.  Click OK to finish.   
 
 

Configure the Atheros AR5001X Mini PCI Wireless Network Adapter through the Atheros Client Utility.