TOA Corporation WM-D5300 Manuale Utente

 step 1. With the battery cover removed, switch ON the transmitter power switch 

and confirm that the Encryption indicator is lit.

 step 2. Switch OFF the power switch.

 step 3. Switch ON the transmitter power switch while holding down the 

Encryption setting switch.

Do not switch OFF the transmitter power switch during setting.

 step 4. Confirm that the Encryption indicator has extinguished, then release the

Encryption setting switch. 

The encryption setting switches to OFF.

By presetting the specified code between the wireless transmitter and receiver, audio is only output

when a digital signal received from the wireless transmitter has the same ID code as the receiver. 

Even if another signal is received from an adjacent area, if the code does not match, audio is not 

output. 

Ten varieties of code can be selected ([0] – [9]) for appropriate use, depending on circumstances.

Code is factory-preset to "0."

Switch OFF the transmitter power switch when performing 

settings. If the power switch is left ON, the codes will remain 

unaffected even if the settings are manually changed. 

 step 1. After removing the battery cover, switch ON the 

transmitter power switch. 

 step 2. Confirm that the Encryption indicator is unlit.

If it is lit, switch encryption from ON to OFF, referring to 

 step 3. Switch OFF the power. 

 step 4. Using the supplied screwdriver, set the code setting 

switch to the desired code number.

 step 5. Replace the battery cover, as it was before.

This puts the code into the set state. 

 step 6. Set the same code number for the receiver, as well. 

For the setting method, see the instruction manual 

enclosed with the receiver. 

H

L

Screwdriver

(accesory)

Unit

Unlit

Lit