TOA Corporation WM-D5300 Manuale Utente

Transmission can be set for either of two outputs: ‘H’ (10 mW) or ‘L’ (1 mW).

The switch is factory-preset to the ‘H’ position.

Be sure to turn the transmitter’s power switch OFF before performing settings. 

 step 1. Confirm  that  the  power  switch  is  turned  OFF,  then

remove the battery cover. 

 step 2. Using the supplied screwdriver, set the changeover 

switch to the desired transmission output. 

Set  the  switch  to  the  ‘H’  position  when  using  the

transmitter in a wide area. 

If the same bank and channel are used in close 

proximity in adjacent locations, set the switch to the 

‘L’ position to shorten the radio wave transmission 

range for each location to minimize interference. 

 step 3. Securely replace the battery cover. 

H

L

H

L

Screwdriver

(accesory)

Transmission output 

changeover switch