Honeywell International Inc. 9PGTPL-100A Manuale Utente
Page 2001
1 Mar 2006
34-45-54
MAINTENANCE MANUAL
TPL-100A Processor / Part No. 940-0530-001
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
MAINTENANCE PRACTICES
1.
Overview
A. General
The purpose of this section is to supply service personnel with installation and maintenance
information pertaining to the MILACAS-FR system. This information pertains to the
components that follow:
information pertaining to the MILACAS-FR system. This information pertains to the
components that follow:
•
MILACAS-FR Processor
•
ANT-81A Directional Antenna
•
Mode S Transponder (APX-100/APX-119).
Installation and maintenance information for the Mode S transponder, control units, and
transponder associated omni antennas are described in the applicable Mode S transponder
system maintenance manual.
transponder associated omni antennas are described in the applicable Mode S transponder
system maintenance manual.
Installation instructions are supported by mechanical outline drawings and electrical
interconnection drawings. These drawings, located at the back of this section, should be
reviewed by the installing agency and special requirements that refer to the particular
airframe must be identified before installation starts.
interconnection drawings. These drawings, located at the back of this section, should be
reviewed by the installing agency and special requirements that refer to the particular
airframe must be identified before installation starts.
2.
Inspection and Unpacking
Use care when unpacking the MILACAS-FR system components. Open shipping cartons and
carefully remove all items. Check the contents to make sure that all items identified on the
packing list are included. Visually inspect each component for damage incurred during
shipment. Look for dents, deep abrasions, chipped paint, and other damage. If a component is
damaged, notify the transportation carrier immediately.
carefully remove all items. Check the contents to make sure that all items identified on the
packing list are included. Visually inspect each component for damage incurred during
shipment. Look for dents, deep abrasions, chipped paint, and other damage. If a component is
damaged, notify the transportation carrier immediately.
The components of the MILACAS-FR Processor have been adjusted and tested prior to
shipment. Therefore, preinstallation testing is not required. If preinstallation bench testing of the
units is desired, refer to the Testing and Troubleshooting section of the component maintenance
manual for the applicable unit.
shipment. Therefore, preinstallation testing is not required. If preinstallation bench testing of the
units is desired, refer to the Testing and Troubleshooting section of the component maintenance
manual for the applicable unit.
Honeywell uses a standardized marking system to identify equipment that has changes
incorporated. Refer to the front of the applicable component maintenance manual for a list of
service bulletins that change the various units in the system.
incorporated. Refer to the front of the applicable component maintenance manual for a list of
service bulletins that change the various units in the system.
3.
Installation Planning
A. General
The paragraphs that follow contain information about the initial installation of the
MILACAS-FR Processor and supply instructions about the location and installation of the
various components of the system.
MILACAS-FR Processor and supply instructions about the location and installation of the
various components of the system.