Honeywell International Inc. KT73 Manuale Utente

Rev 0, October/2002

10563I00.JA

Page 3-1

3.1

GENERAL

Section 3 describes the operation of the KT 73.  Where applicable, illustrations of the displays are 
furnished to assist the operator in understanding the operation of the unit and also provide a visual 
aide for programming sequences.  Figure 3-1 illustrates the various panel controls and displays of 
the unit.

NOTE:

The KT 73 and all other avionics, should be turned
off before starting the aircraft engine(s).

3.2

PROGRAMMING MODE

NOTE:

While in the programming mode, the KT 73 will not
transmit RF energy.

The programming mode is entered using the following procedure:

(1)

Place the unit in Standby mode.

(2)

Select 0000 ident code.

(3)

Simultaneously depress the IDT and VFR buttons for a minimum of 2 seconds.

To select the programming mode menu, rotate the cursor (CRSR) knob either clockwise or 
counter clockwise to advance either up or down, respectively, through the following menu options 
and then depress the IDENT button.

(1)

A/C ADDR      (Aircraft Address)

(2)

MAX AIR        (Maximum Airspeed)

Impress Tryout