Honeywell International Inc. KXP2290 Manuale Utente

n

 Rev. 0c, June/2006 Preliminary 05/24/06 10689I00.JA

Page 1-5

Use the following parts for installations using 

. (ECS cable only)

Use the following parts for installations using 

. (ECS cable with RG-400 cable).

1.6

LICENSING REQUIREMENTS

This equipment has been type accepted by the FCC and entered on the type accepted equipment 
list, as FCC ID: ASYKXP2290??.

For non-US registered aircraft, follow applicable licensing requirements as required.

1.7

CONTINUED AIRWORTHINESS INSTRUCTIONS

1.7.1

EQUIPMENT

FAA requires that transponders, including the KXP 2290, be tested and inspected and found to 
comply with Federal Aviation Regulation (FAR) Appendix F of Part 43 of chapter 91.413, ATC tran-
sponder tests and inspections  This requirement is applicable previous to or at the time of instal-
lation of a new unit and again at two year intervals for any unit.

Other than the FAR noted above, there are no periodic service requirements necessary to main-
tain continued airworthiness. No maintenance is required until the equipment does not properly 
perform its intended function.   When service is required, a complete performance test should be 
accomplished following any repair action. Consult the appropriate unit Maintenance/Overhaul 
Manual for complete performance test information.

1.7.2

WIRES/COAX CABLES

During on-condition or regularly scheduled maintenance, inspect the wires and coax cables fol-
lowing the guidelines listed in AC 43,13-1 Chapter 15 as necessary.