Honeywell International Inc. WFSRM Manuale Utente

12

SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000NF-E:C 5/8/2015

FWSG FlashScan Wireless System Gateway

The profile magnetic sensor (refer to Figure 2.2) is used to create a unique profile upon start-up. It 
can also be used to start profile distribution for a gateway that contains a profile. The LED next to 
the profile magnet sensor turns on green for ½ a second when the sensor is activated.

The mesh formation magnetic sensor (refer to Figure 2.2) toggles the gateway in and out of mesh 
formation mode. The initial activation of the sensor puts the gateway in mesh formation mode (as 
long as it contains a profile). A subsequent activation of the magnetic sensor toggles the gateway 
out of mesh formation and into the initial mesh restructuring and normal mode. The gateway can be 
placed back into mesh formation mode by activating the magnet sensor once again. The LED next 
to the profile magnet sensor turns on green for ½ a second when the sensor is activated.

The Mesh formation magnetic sensor can also be used to create a profile on start-up for a gateway 
that does not already contain a profile.

The two LEDs on the gateway blink in the same pattern to allow the LED to be viewed from any 
angle. LED patterns are explained in Appendix D.

Choose a location for the gateway that is clean, dry, and vibration-free. The area should be readily 
accessible with sufficient room to easily install and maintain the gateway. Metal obstructions 
impede the radio frequency communication and should be avoided. Carefully unpack the system 
and inspect for shipping damage if any. All wiring must comply with the national and local codes 
for fire alarm systems. 

LEDs

Mesh 

Formation 

Magnetic 

Sensor

Profile 

Magnetic 

Sensor

cove

r.

wmf