Honeywell International Inc. WFSSM Manuale Utente

40

SWIFT® Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000SK-E:B  11/9/2017

The W-USB is a software interface that can be connected to a PC (running SWIFT Tools) through a USB port. It communicates with the 
RF devices using the same frequencies as the mesh protocol. This device is powered directly by the USB port.
The LED gives an indication of power and initialization status.

The W-USB has an adjustable USB connector to facilitate connection by reducing the size when connected to a laptop/tablet. 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 
1.

This device may not cause harmful interference, and 

2.

This device must accept any interference received, including interference that may cause undesired operation.

This device utilizes the Honeywell915 rev A radio module and complies with IFETEL standard(s).
IFT: RCPSYWU14-1829

•

Operating voltage: 4.3 VDC - 5.5 VDC (5VDC typical)

•

Supply current: 25 mA - 85 mA (33 mA typical)

•

USB standard 2.0 

•

USB Connector type A

•

Length with connector closed: 3 in. (76.2 mm)

•

Length with connector open: 3.8 in. (96.2 mm)

•

Thickness on connector side: 0.5 in (13 mm)

•

Thickness on antenna side: 0.3 in. (8.4 mm)

Red

Device has power but is not initialized or the driver is missing.

Yellow

Device is initialized and ready.

Blue

Device is updating or failed to load properly. Complete the update or re-
power the device. If problems persist, contact technical support.

usb

.w

m

f

WARNING: DO NOT MAKE CHANGES TO THE EQUIPMENT.
CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER’S 

AUTHORITY TO OPERATE THE EQUIPMENT.