High-Flying Electronics Technology Co. Ltd HF-A11X Manuale Utente
HF-A11x V3.1 User Manual
Shanghai High-Flying Electronics Technology Co., Ltd
www.hi-flying.com
45
NONE: When “auth=OPEN”, effective
WEP: When “auth=OPEN” or “SHARED”, effective
TKIP: When ”auth= WPAPSK”, effective
AES: When “auth= WPAPSK”, effective
WEP: When “auth=OPEN” or “SHARED”, effective
TKIP: When ”auth= WPAPSK”, effective
AES: When “auth= WPAPSK”, effective
key: password, ASCII code, shall less than 64 bit and
greater than 8bit
This Instruction only effective for HF-A11x works as STA. After HF-A11x module boots up again,
the setting will be effective. But user can set this command when module configured as AP.
the setting will be effective. But user can set this command when module configured as AP.
4.2.2.11. AT+WSSSID
Function: Set/Query WIFI target AP SSID parameters as STA.
Format:
Format:
Query
Operation
AT+WSSSID<CR>
+ok=<ap’s ssid><CR>< LF ><CR>< LF >
Set
Operation
AT+ WSSSID=<ap’s ssid ><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
ap’s ssid: AP’s SSID
This Instruction only effective for HF-A11x works as STA. After HF-A11x module boots up again,
the setting will be effective. But user can set this command when module configured as AP.
the setting will be effective. But user can set this command when module configured as AP.
4.2.2.12. AT+ WSLK
Function: Query WiFi link status as STA
Format:
Format:
Query
Operation
AT+ WSLK<CR>
+ok=<ret><CR>< LF ><CR>< LF >
Parameters:
ret
”Disconnected”, if no WiFi connection;
”AP’
”AP’
SSID(AP’s MAC” ), if WiFi connection available;
”RF Off”, if WiFi OFF;
This Instruction only effective for HF-A11x works as STA. After HF-A11x module boots up again,
the setting will be effective. But user can set this command when module configured as AP.
the setting will be effective. But user can set this command when module configured as AP.
4.2.2.13. AT+ WSLQ
Function: Query WiFi signal strength as STA
Format:
Format:
Query
Operation
AT+ WSLQ<CR>
+ok=<ret><CR>< LF ><CR>< LF >
Parameters:
ret
”Disconnected”, if no WiFi connection;
”AP’s WiFi signal strength” , if WiFi connection available;
”AP’s WiFi signal strength” , if WiFi connection available;
This Instruction only effective for HF-A11x works as STA. After HF-A11x module boots up again,
the setting will be effective. But user can set this command when module configured as AP.
the setting will be effective. But user can set this command when module configured as AP.
4.2.2.14. AT+WEBU
Function: Set/Query WEB page login parameters;
Format:
Format:
Query
Operation