Manualsbrain.com
  1. Manuali
  2. Marche
  3. HP
  4. RSVLC-0301B
  5. Manuale Utente

HP RSVLC-0301B Manuale Utente

Scarica
Pagina di 100
3-3
Getting Started With Access Point Configuration
Ge
ttin
g
 S
ta
rte
d
 With
 Ac
c
e
ss 
Po
in
t Co
n
fig
u
ra
tio
n
3.
Type 
configure to enter global configuration mode.
4.
Type 
management to enter management configuration.
5.
Type 
username-admin username to create a user name for the Manager, 
where 
username can consist of 3 to 16 alphanumeric characters and is case 
sensitive. 
6.
Type 
password-admin password to create a password for the Manager, 
where 
password can consist of up to 16 alphanumeric characters and is 
case sensitive.
To Set the Access Point’s IP Address
By default, the access point is configured to automatically receive IP 
addressing from a Dynamic Host Configuration Protocol (DHCP) server. 
However, if you are not using a DHCP server to configure IP addressing, use 
the CLI to manually configure the IP values.
1.
From the global configuration mode, type 
interface ethernet to access the 
Ethernet interface-configuration mode.
HP ProCurve Access Point 420#configure
Enter configuration commands, one per line.
HP ProCurve Access Point 420(config)#
HP ProCurve Access Point 420(config)management
Enter management commands, one per line.
HP ProCurve Access Point 420(config-mgmt)#
HP ProCurve Access Point 420(config-mgmt)#username-admin steve
HP ProCurve Access Point 420(config-mgmt)#
HP ProCurve Access Point 420(config-mgmt)#password-admin 1AB2F
HP ProCurve Access Point 420(config-mgmt)#
HP ProCurve Access Point 420(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
HP ProCurve Access Point 420(if-ethernet)#