Справочник Пользователя для HP RSVLC-0301B
3-3
Getting Started With Access Point Configuration
Ge
ttin
g
ttin
g
S
ta
rte
d
With
Ac
c
c
e
ss
Po
in
in
t Co
n
fig
u
u
ra
tio
n
n
3.
Type
configure to enter global configuration mode.
4.
Type
management to enter management configuration.
5.
Type
username-admin username to create a user name for the Manager,
where
username can consist of 3 to 16 alphanumeric characters and is case
sensitive.
6.
Type
password-admin password to create a password for the Manager,
where
password can consist of up to 16 alphanumeric characters and is
case sensitive.
To Set the Access Point’s IP Address
By default, the access point is configured to automatically receive IP
addressing from a Dynamic Host Configuration Protocol (DHCP) server.
However, if you are not using a DHCP server to configure IP addressing, use
the CLI to manually configure the IP values.
addressing from a Dynamic Host Configuration Protocol (DHCP) server.
However, if you are not using a DHCP server to configure IP addressing, use
the CLI to manually configure the IP values.
1.
From the global configuration mode, type
interface ethernet to access the
Ethernet interface-configuration mode.
HP ProCurve Access Point 420#configure
Enter configuration commands, one per line.
HP ProCurve Access Point 420(config)#
Enter configuration commands, one per line.
HP ProCurve Access Point 420(config)#
HP ProCurve Access Point 420(config)management
Enter management commands, one per line.
HP ProCurve Access Point 420(config-mgmt)#
Enter management commands, one per line.
HP ProCurve Access Point 420(config-mgmt)#
HP ProCurve Access Point 420(config-mgmt)#username-admin steve
HP ProCurve Access Point 420(config-mgmt)#
HP ProCurve Access Point 420(config-mgmt)#
HP ProCurve Access Point 420(config-mgmt)#password-admin 1AB2F
HP ProCurve Access Point 420(config-mgmt)#
HP ProCurve Access Point 420(config-mgmt)#
HP ProCurve Access Point 420(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
HP ProCurve Access Point 420(if-ethernet)#
Enter Ethernet configuration commands, one per line.
HP ProCurve Access Point 420(if-ethernet)#