Bionime Corporation GM232 Manuale Utente

17

16

 

 

 

 Meter Activation and Battery Change

Your 

Blood Glucose Meter comes with two AAA, batteries installed. Two new batteries will 

provide power to perform approximately 800 tests under normal use with one data transfer. Press the 
main button or insert a strip to activate your meter.

GE006 

4. The GE006 Blood Glucose Meter 

5. Press any button to exit the self-test and enter Setting Mode.

will enter Self-Testing Mode automatically when replacing the battery 

(all symbols will appear on the screen).

6. You must set the time and date when replacing the battery. See Chapter “Setting Up Your Meter - 

Setting the Date, Time, and Volume" on page 18. Test results are still stored in the memory.

1. Turn the 

over. Press and slide the 

battery cover to open.

GE006 Blood Glucose 

Meter 

2. Install the batteries. Be sure to 

put the batteries in the correct 
direction.

3. Slide the battery cover 

back until it snaps into 
place.

Meter Activation and Battery Change

   

CAUTION
- Please follow the local regulation to properly discard a used battery.
- Risk of explosion if battery is replaced by an incorrect type.

You can enter the Setting Mode two ways.

2. With Battery Inserted
    

  After removing the battery, press the main button several times until there is no signal on screen, 

then follow the battery installation steps to replace battery. The GE006 Blood Glucose Meter will 
perform a self-test. Press the main button to exit the self-test and enter the Setting Mode.

Press the main button to turn on the GE006 Blood Glucose Meter. Hold down the main button for 7 

seconds. During this time the screen will go blank until you hear a beep. After the beep, the meter will 
turn on into the Setting Mode. The display screen will show setting data.

NOTE
- Use the Left and Right buttons to select your setting data and press the main button to 

confirm each selection. After confirming all of the settings, you will return to the Time Mode.