Bionime Corporation GM782 Manuale Utente

51

50

Er1 - 

Er2 - The m

Er3 - The s

The inserted test strip has been used or damaged. Please use a new test 
strip.

eter has malfunctioned. Do a Quality Control Test or reinstall the 

batteries to check if the meter works properly.

ignal transmission is disrupted. Repeat the test using a new test strip.

Repeat the test using a new test 

strip.

Er5 - An issue calibrating the Meter has occurred. Please follow the steps below:

  (1) Remove the test strip from the meter.
  (2) Turn off the meter (press and hold the Main button for 3 seconds).
  (3) Press the main button to turn ON the meter.

  If after turning on the Meter, you do not see Er5, your meter is functioning 

properly and able to perform a test.

If one of the above error messages still appears, please contact Bionime  
Customer Service.

Er4 - The blood sample volume is insufficient. 

Meter Malfunction
If the 

 Blood Glucose Meter

 will not turn on, please follow the steps below:

1. Open the battery cover and remove the batteries.
2. Wait for 5 minutes and reinsert the batteries as described as instructed on page 16, (Meter 

Activation and Changing the Battery).

The meter should work normally after finishing the above steps. If the meter still does not work, 
please contact your local 

 customer service.

 Rightest

GM782

 

Bionime

Strip Error

"           "

"          "

"          "

Sampling Error
Please do not apply the blood to the sample port of the test strip before the 
meter displays "      ". Discard the test strip If the meter shows "          ".

1. When the test strip is inserted incorrectly, the meter will beep 4 times while the 

 symbol flashes. Do not apply a sample on the test strip. Please re-

insert the unused test strip correctly (refer to “Handling the 

 Blood 

Glucose Test Strip GS700“ on Page 23 for more information).

2. If, after performing the required steps, the 

 and flashing 

 

symbols appear on the screen, it means the 

 Blood Glucose Test 

Strip GS700 has been inserted incorrectly more than twice. Please, re-insert 
the unused test strip again after reviewing the steps on how to insert a test 
strip correctly on p.23 or call Customer Service for support. This error message 
can also indicate that you may have used the wrong test strips. Please check 
the test strip vial to ensure you are using the 

 Blood Glucose Test 

Strip GS700. 

Battery Error
1. The "         " and "          " symbols appear and the meter will not function when 

the battery is low. Change the batteries immediately.