ICOM 242700 Manuale Utente

115

9

SCAN OPERATION

qSelect VFO mode, then set a frequency.

wClose the squelch with [RF/SQL].

eSet the desired memory channel as the watching

channel.

rSelect S-2.

tPush [F-2 PRI] to start the priority watch.

• “

” appears and decimal point blink while scanning.

yWhen the scan detects a signal, the scan pauses

for 10 sec. or until the signal disappears, depend-
ing on the resume setting.

uTo cancel the scan push [F-2 PRI].

NOTE: The paused condition when detecting a sig-
nal differs depending on the scan resume condi-
tion. (p 134)

resume on: pauses for 10 sec.
resume off: pauses until the signal disappears.

Select
VFO mode.

Select watching
channel.

Push [F-2 PRI].

[MENU/GRP] [F-2]

[RF/SQL]

Appears while scanning

qSelect S-2.

wPush [F-3 V/M] to select memory mode.

eClose the squelch with [RF/SQL].

rPush [F-1 SCN] to start the memory scan.

• Decimal point blinks while scanning.

tPush [F-2 SEL] to change the memory scan to se-

lect memory scan.

yWhen the scan detects a signal, the scan stops or

pauses depending on the resume setting.

uTo cancel the scan push [F-1 SCN].

NOTE: Two or more memory channels must be
designated as select memory channels for select
memory scan to start (see p. 106).

While scan function is not activate, pushing 

SEL

] sets the select memory channels ON or OFF.

And pushing and holding 

[F-2 SEL] for 2 sec.

clears the all select memory channels.

Designate
“

★.”

Select
memory mode.

Push [F-1 SCN],
then push [F-2 SEL].

[MENU/GRP] [F-1] [F-2] [F-3]

[RF/SQL]

■Select memory scan operation

■Priority watch

Push

[MENU/GRP] for 1 sec. 

Selection from: M, S or G(Graphic)

Push

[MENU/GRP] momentarily. 

Selection from: S-1, S-2 or S-3

Either

Y or Z

Either

Y

 or 

Z