ICOM 297000 Manuale Utente
20
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Receiving
q Set the audio level for the main band.
➥ Push the desired band’s [MAIN•BAND].
➥ Push and hold [DUP•MONI] for 1 sec. to open the
squelch.
➥ Rotate the main band’s [VOL] to adjust the audio level.
➥ Push the [DUP•MONI] to close the squelch.
w Set the squelch level.
➥ Rotate the main band’s [SQL] fully counterclockwise in
advance, then rotate the [SQL] clockwise until the noise
just disappears.
just disappears.
• When interference due to strong signals is received, rotate
the [SQL] clockwise again for attenuator operation. (p. 17)
e Set the operating frequency in the main band. (pgs. 11–13)
r When receiving a signal on the set frequency, squelch
r When receiving a signal on the set frequency, squelch
opens and the transceiver emits audio.
• “BUSY” appears and the S/RF
indicator shows the relative
signal strength for the re-
ceived signal.
signal strength for the re-
ceived signal.
✔
CONVENIENT!
The main band’s audio and squelch level can also
be adjusted with [
be adjusted with [
VOL
Y(TONE-1)]/[
VOL
Z 0(TONE-2)]
and [
SQL
Y
D(MUTE)]/[
SQL
Z
#(16KEY-L)], respectively.
• “VOL” for audio or “SQL” for squelch appears during set.
■ Transmitting
☞ NOTE: To prevent interference, listen on the channel be-
fore transmitting by pushing and holding [DUP•MONI] for
1 sec., or [
1 sec., or [
MONI
1(BANK)] on the microphone.
q Select the main band. (p. 11)
w Set the operating frequency. (pgs. 11–13)
w Set the operating frequency. (pgs. 11–13)
• Select output power if desired. See section at right for details.
e Push and hold [PTT] to transmit.
• “$” appears.
• The S/RF indicator shows the output power selection.
• A one-touch PTT function is available. See p. ?? for details.
• “
• The S/RF indicator shows the output power selection.
• A one-touch PTT function is available. See p. ?? for details.
• “
” appears on the sub band screen according to the se-
lected frequency band.
r Speak into the microphone using your normal voice level.
• DO NOT hold the microphone too close to your mouth or speak
too loudly. This may distort the signal.
t Release [PTT] to return to receive.
IMPORTANT! (for 50 W transmission):
The IC-2820H is equipped with protection circuit to protect
the power amplifier circuit from high SWR
The IC-2820H is equipped with protection circuit to protect
the power amplifier circuit from high SWR
(Standing Wave
Ratio)
and temperature. When a high SWR antenna or no
antenna is connected, or when the transceiver temperature
becomes extremely high, the transceiver reduces transmit
output power to
becomes extremely high, the transceiver reduces transmit
output power to
15
W (approx.) automatically.
CAUTION: Transmitting without an antenna will damage
the transceiver.
Show set level.
SQLY/Z
D/#
VOLY/Z
M/0
Appears when receiving a signal.