ICOM 301500 Manuale Utente

75

10

SET MODE

N Set mode (Continued)

A beep sounds when an operating frequency enters or 
exits an amateur band. This function is independent from 
“Beep” (the confirmation beep) setting as above.

on  : Band edge beep ON
oF  : Band edge beep OFF

The volume level can be set in “Beep Level” as below.

ON (default)

This item sets the maximum volume level for the con-
firmation beep and band edge beep tones from 0% to 
100% in 1% steps. 
When beep tones are set to OFF, this setting has no ef-
fect.

50% (default)

Turn the beep tones output level limiting capability ON 
and OFF for the confirmation and band edge beep tones. 
When this item is set to ON, the beep tones are linked to 
the [AF] control until rotation of the [AF] control reaches 
to the specified level—further rotation will not increase 
the volume of the beep tones.

on  : Beep level is limited with the [AF] control
oF  : Beep level is linked to the [AF] control

ON (default)

The [RF/SQL] control can be set as the RF/squelch con-
trol, the squelch control only (RF gain is fixed at maxi-
mum) or Auto (RF gain control in SSB, CW and RTTY; 
squelch control in AM).
See pgs. 4, 30 for details.

rS (RF+SQL)  :  [RF/SQL] control is set as the RF/squelch 

control

Sq (SQL) 

:  [RF/SQL] control is set as the squelch 

control

At (AUTO) 

:  [RF/SQL] control is set as the RF gain 

control in SSB, CW and RTTY; squelch 
control in AM

RF +

 SQL (default)

This item turns the meter peak hold function ON or OFF.

on :  

The highest activated segment of the meter remains 
visible for 0.5 sec.

oF  : The meter functions normally.

ON (default)