ICOM 316800 Manuale Utente
20
7
SET MODE
D Power save function
“PS”
The power save function reduces current drain by deactivat-
ing the receiver circuit for preset intervals.
ing the receiver circuit for preset intervals.
• OFF : The power save function is turned OFF.
• ON : The power save function is turned ON. The power save
• ON : The power save function is turned ON. The power save
function will be activated when no signal is received, and no
operation is performed for 5 sec.
operation is performed for 5 sec.
D Squelch sensitivity
“SS”
When this function is turned ON, rejection of noise is im-
proved so that the audio is not easily affected by noise.
proved so that the audio is not easily affected by noise.
D Low fix function
“LF”
(Appears only when the optional battery case is attached.)
When this function is turned ON, the output power is fixed to
low except for Channel 16.
When this function is turned ON, the output power is fixed to
low except for Channel 16.
Push
Low fix function
OFF (default)
Low fix function ON
D Noise detection function
“nd”
The noise detection function enables the transceiver to de-
tect the ambient noise while in the standby condition. If the
detecting noise and the received signal are stronger than the
specific level, the transceiver increases the volume level au-
tomatically to suit the environment when receiving a signal.
tect the ambient noise while in the standby condition. If the
detecting noise and the received signal are stronger than the
specific level, the transceiver increases the volume level au-
tomatically to suit the environment when receiving a signal.
When the squelch is open, the transceiver won't detect noise.
• OFF : The noise detection function is turned OFF.
• Low : When the detecting noise is louder than the specific level,
• Low : When the detecting noise is louder than the specific level,
the transceiver turns up the volume.
• High : When the detecting noise is louder than the specific level, the
transceiver turns up the volume greater than "Low" setting.
Push
Power save ON
(default)
Power save OFF
Push
Noise detection function
OFF (default)
Noise detection function
ON (High)
Push
Squelch sensitivity
OFF (default)
Squelch sensitivity
ON