ICOM 322800 Manuale Utente
New2001
14
New2001
BASIC OPERATION
4
■
Turning power ON
IMPORTANT:
BE SURE
to connect the GPS receiver to
the transponder before turning the power ON. (p. 35)
q
Hold down
[POWER•BRILL]
for 1 second to turn ON the
power.
•
A long beep sounds, and the opening screen appears.
[POWER•BRILL]
w
The opening screen displays the results of the ROM, RAM
and backup data test, “OK” or “NG” (No Good).
•
If “NG” is displayed, hold down
[POWER•BRILL]
for 1 second to turn
OFF the power, then ON again to reset the transponder. If there is no
change, contact your dealer or service center.
change, contact your dealer or service center.
e
After the opening test is completed, the MMSI code ap-
pears, if the code has already been set.
• “No MMSI” appears when no MMSI code is set.
(p. 7)
r
The GPS search display appears while searching for a
GPS satellite.
• While searching, the GPS information screen can be displayed
by pushing [ENT], or you can enter the Menu mode by pushing
[MENU]. (pp. 28, 31)
[MENU]. (pp. 28, 31)
t
When the GPS receiver receives signals from a satellite,
the transponder automatically displays the position data
on the plotter display. (p. 15)
on the plotter display. (p. 15)