ICOM 325100 Manuale Utente

■ General description

The transceiver has 207 memory channels including 6 
scan edge memory channels (3 pairs), and 1 Call chan-
nel. These channels can be individually programmed 
with: 
• Operating frequency (p. 5)
• Duplex direction (p. 12) and offset (p. 15)
•  Subaudible tone or tone squelch and tone frequency 

(pp. 13, 39–41)

• Skip setting* (p. 32)

In addition, a total of 10 memory banks; A to J, are se-
lectable for use by groups, and so on.
*except for scan edge memory channels.

■

The VFO settings, including the Set mode contents 
such as subaudible tone frequency, and so on, can be 
programmed into a memory channel.

q Set the desired frequency in the VFO mode.

w Push [S.MW].
 • 

The 

“

” icon and the memory channel number blink.

e  Rotate [DIAL] to select the memory channel to be 

programmed.

 • 

 

If the selected channel is blank, only the memory 
channel number is displayed.

r Hold down [MW] (S.MW) for 1 second to program.
  • 3 beeps sound.
 • 

 

The memory channel number increases, when 
continuing to hold down [MW]  (S.MW)  after pro-
gramming.

✔CONVENIENT
Memory programming can be performed in several 
ways. Example; Programming the memory channel to 
the same (or different) memory channel, memory chan-
nel to the Call channel, and so on.

z Set the desired frequency in the VFO mode.

x Push [FUNC] 

, and then push [MW] 

.

 • 

The 

“

” icon and the memory channel number blink.

c  Push [Y] or [Z] to select the memory channel to be 

programmed. (direct numeric input cannot be used.)

v  Push [FUNC] 

, and then hold down [MW] 

 for 

1 second to program.

  ➥  3 beeps sound and the VFO contents (including 

the subaudible tone frequency, and so on.) are 
programmed.

  ➥  The memory channel number increases, when 

continuing to hold down [MW] 

 after program-

ming.

17

[i.e.]:  Programming 145.870 MHz into memory chan-

nel 20 via the front panel.

[i.e.]:  Programming 145.870 

MHz into the memory 

channel 20, using the microphone.

5

Push [V/MHz].

Rotate [DIAL] to set the frequency.

Push [S.MW].

Rotate [DIAL] to select the memory channel to be programmed.

Hold down [S.MW] for 1 second. 

Push           .

Push                                                            .

Push         , and then         .

Push           /          .

Push         , and then hold down         for 1 second.