ICOM 339300 Manuale Utente
1
PANEL DESCRIPTION
1-7
Previous view
@2 SPEECH/LOCK SWITCH
SPEECH
❍ SPEECH KEY Operation (p. 45)
Push to audibly announce the S-meter level, the
displayed frequency and the operating mode.
displayed frequency and the operating mode.
•
The S-Level announcement can be turned OFF in the
“S-Level SPEECH” item of the “SPEECH” Set mode.
(p. 164)
“S-Level SPEECH” item of the “SPEECH” Set mode.
(p. 164)
SET
> SPEECH > S-Level SPEECH
• When RIT is ON, the RIT offset is not included in the
frequency announcement.
❍ LOCK KEY Operation (p. 77)
Hold down for 1 second to turn the Lock function
ON or OFF.
ON or OFF.
•
The function electronically locks the Dial.
•
“
” appears when the function is ON.
•
The function can be select the Dial lock and Panel
lock in the “Lock Function” item of the “Function” Set
mode. (p. 164)
lock in the “Lock Function” item of the “Function” Set
mode. (p. 164)
SET
> Function > Lock Function
NOTE: The [SPEECH/LOCK] switch operation to
activate the voice synthesizer or the Lock func-
tions can be replaced in the “[SPEECH/LOCK]
Switch” item of the “Function” Set mode. (p. 164)
activate the voice synthesizer or the Lock func-
tions can be replaced in the “[SPEECH/LOCK]
Switch” item of the “Function” Set mode. (p. 164)
SET
> Function > Lock Function
@3 MEMO PAD KEY
MPAD
(p. 144)
Push to sequentially call up the contents from the
➥
memo pads.
The 5 (or 10) most recently programmed frequen-
cies and operating modes can be recalled, start-
ing from the most recent.
cies and operating modes can be recalled, start-
ing from the most recent.
•
The memo pad capacity can be increased from 5 to
10 in the “Memopad Numbers” item of the “Function”
Set mode (p. 164)
10 in the “Memopad Numbers” item of the “Function”
Set mode (p. 164)
SET
> Function > Memopad Numbers
Hold down for 1 second to write the displayed
➥
data into a memo pad.
•
The 5 most recent entries remain in the memo pads.
@4 MAIN DIAL
Rotate to change the displayed frequency, select the
Rotate to change the displayed frequency, select the
Set mode settings, and so on.
@5 MAIN DIAL TENSION LATCH
Select the Dial drag.
Select the Dial drag.
•
Three positions are selectable. The upper side setting
turns on clicks as the dial is turned.
turns on clicks as the dial is turned.
Front panel (Controller) (Continued)
PBT
RIT
TX / RX
PWR
AF
RF/SQL
CLR
M-CH
BANK
RIT
TUNER/CALL
MENU
MIC/RF PWR
NB
SPEED/PITCH
SET
QUICK
NOTCH
DR
AUTO TUNE RX
➔
CS
XFC
SPEECH
MPAD
NR
P.AMP ATT
i7100
@2 @3
@4
@5