ICOM 366400 Manuale Utente
8
NXDN OPERATION <CONVENTIONAL MODE>
8-5
Transmitting a call (Continued)
Status call
D
The status call is a simple message function to transmit
and receive a status message. A transceiver can dis-
play the status message quickly. You cannot transmit a
voice signal at the same time.
and receive a status message. A transceiver can dis-
play the status message quickly. You cannot transmit a
voice signal at the same time.
Push [Status (NXDN)] to enter the Status Message
q
Select mode.
• Displays “STATUS.”
Push [UP] or [DOWN] to select a desired status
w
message.
• If you want to directly enter a status message, push [P2]
(MODE) to select the Status Message Entry mode.
You can enter a status message between 1 and 207.
• You can use the 10-keypad keys on the microphone.
• You can use the 10-keypad keys on the microphone.
STATUS
STATUS 001
Push [P3](TX) or [PTT] to send the selected Status
e
Message.
• Displays “SEND DATA” and then “COMPLETE.”
Short Data call
D
You can send a Short Data message of up to 100 char-
acters.
If you turn OFF the transceiver’s power, the message
is cleared.
acters.
If you turn OFF the transceiver’s power, the message
is cleared.
Push [SDM (NXDN)] to enter the Short Data Mes-
q
sage Entry mode.
• Displays “MESSAGE?”.
MESSAGE?
Push [UP] or [DOWN] to enter a character, and then
w
push [P1](SET) to set.
• Goes to the next character entry position.
• You can use the 10-keypad keys on the microphone.
• You can use the 10-keypad keys on the microphone.
Repeat step
e
w
until you enter a message of up to
100 characters.
• Push [P0](DEL) to delete a character.
• Push [P2](Ω) or [P3](≈) left or right to select a charac-
• Push [P2](Ω) or [P3](≈) left or right to select a charac-
ter.
SHORT MESSAG
Push [PTT] to send.
r
• Displays “SEND DATA” and then “COMPLETE.”
Push [P1](EXIT) to exit.
t
If you exit from the Short Data Message Entry mode,
and then you want to transmit the message again, do
the following steps.
and then you want to transmit the message again, do
the following steps.
Push [SDM (NXDN)] to enter the Short Data Mes-
q
sage Entry mode.
• Displays the entered message.
• Displays the last part of the message if the message is
• Displays the last part of the message if the message is
over 12 characters.
HORT MESSAGE
Push [PTT] to send.
w
• Displays “SEND DATA” and then “COMPLETE.”
Push [P1](EXIT) to exit.
e
Long Data call
D
You can send a Long Data message of up to 4,096
characters only by using an external device, such as a
PC. You cannot send a message by pushing [PTT].
characters only by using an external device, such as a
PC. You cannot send a message by pushing [PTT].