ICOM 375410 Manuale Utente
30
6
SCANNING
6
201802
201802
BASIC MANUAL
■
About Scans
[DIAL] operation during a scan
•Rotate [DIAL] to change the scan
direction during a scan.
•When the scan is paused, rotate [DIAL] to
resume the scan.
Squelch setting for a scan
You can change the squelch level to suit
your operating needs. Set the squelch
level to open the squelch, according to the
received signal strength.
L
During a scan, rotate [DIAL] while holding
down [SQL] to adjust the squelch level.
The scan resumes after adjusting.
Tuning step for a VFO scan
The selected tuning step is applied to the
scan.
For a Program scan or Program Link scan,
set the tuning step in the Program Scan
ranges (P-Scan Edge).
Scan Skip function*
The skip function speeds up scanning by
not scanning those frequencies set as skip
channels.
In the VFO mode
The frequencies that are set as “PSKIP”
are skipped during a scan.
(p. 37)
In the Memory mode
The frequencies that are set as skip
channels “PSKIP” and “SKIP” are not
scanned.
(p. 37)
L
You must enter 2 or more Memory
channels to start a memory scan.
TIP: When Program Skip is set to OFF,
you cannot use the Program Skip scan
function.
(p. 35)
([MENU] > Scan >
Program Skip)
Receiving mode during a scan
•The VFO scan uses the selected
receiving mode.
•During a Memory mode scan, the
receiving mode entered into the channel
is used.
When signal is received
When a signal is received, the scan pauses
for this set period of time.
When a received signal disappears, the
scan resumes for this set period of time.
[MENU] > Scan >
Pause Timer
[MENU] > Scan >
Resume Timer
1. Push [MENU].
2. Select “Pause Timer” or “Resume
Timer” in the “Scan” menu.
3. Select an option, and then push
[ENTER].
Pause Timer*
•2 ~ 20 sec:
When a signal is received, the
scan pauses for 2 ~ 20 seconds
(in 2 second steps).
•HOLD: The scan pauses on a
received signal until the signal
disappears.
Resume Timer*
•0 sec: The scan resumes immediately
after the signal disappears.
•1 ~ 5 sec:
The scan resumes 1 ~ 5
seconds after the signal
disappears.
•HOLD: The scan remains paused for
the
Pause Timer setting, even
if the signal disappears.
NOTE: Rotate [DIAL] to resume the
scan. The
Resume Timer must be set
shorter than the
Pause Timer, otherwise
this timer does not work properly.
* These settings can be separately set to A band and B band.