ICOM IC-R75 Manuale Utente

4

11

■

The receiver uses memory channels for storage of 
frequencies (as well as mode, tuning steps, etc.). When 
turning power OFF or changing memory channels, 
the previously displayed frequency cannot be recalled 
unless it has been stored into a memory channel. 

Therefore,  when  you  want  to  keep  a  displayed 
frequency for later recall, you must program it into a 
memory channel by pushing [MW] for 2 sec.

See p. 22 for details.

■

q

  Push the numeral keys on the keypad to enter the 

MHz digits for the desired frequency.

  •  If a key is mistakenly pushed, push [CLR] and start 

again from the beginning.

  •  When entering the same MHz digits as the displayed 

frequency, this step can be skipped.

w

 Push [•] on the keypad.

e

  Push the numeral keys to enter the frequency 

digits below 1 MHz.

  •  If a key is mistakenly pushed, push [CLR] and start 

again from the beginning.

r

 Push [ENT] to set the input frequency.

  •  When pushing [ENT] after entering the MHz digits, 

zeros are automatically entered for the kHz digits.

“BLANK” appears above the memory channel 
readout until [MW] is pushed for 2 sec.

Push [MW] for 2 sec. after tuning.

[EXAMPLE]: Setting the frequency using the keypad.

•To set to 28.00 MHz

•To set to 21.050 MHz

•To set to 850 kHz (0.850 MHz)

•To change 14.19075 to 14.850 MHz