ICOM IC-R75 Manual Do Utilizador
4
11
FREQUENCY SETTING
■
Read me first
The receiver uses memory channels for storage of
frequencies (as well as mode, tuning steps, etc.). When
turning power OFF or changing memory channels,
the previously displayed frequency cannot be recalled
unless it has been stored into a memory channel.
frequencies (as well as mode, tuning steps, etc.). When
turning power OFF or changing memory channels,
the previously displayed frequency cannot be recalled
unless it has been stored into a memory channel.
Therefore, when you want to keep a displayed
frequency for later recall, you must program it into a
memory channel by pushing [MW] for 2 sec.
frequency for later recall, you must program it into a
memory channel by pushing [MW] for 2 sec.
See p. 22 for details.
■
Using the keypad
q
Push the numeral keys on the keypad to enter the
MHz digits for the desired frequency.
• If a key is mistakenly pushed, push [CLR] and start
again from the beginning.
• When entering the same MHz digits as the displayed
frequency, this step can be skipped.
w
Push [•] on the keypad.
e
Push the numeral keys to enter the frequency
digits below 1 MHz.
• If a key is mistakenly pushed, push [CLR] and start
again from the beginning.
r
Push [ENT] to set the input frequency.
• When pushing [ENT] after entering the MHz digits,
zeros are automatically entered for the kHz digits.
BLANK
BLANK
S1
3
5
7
9
20
40 60dB
AGC
ANT
USB
R X
VFO
1
“BLANK” appears above the memory channel
readout until [MW] is pushed for 2 sec.
readout until [MW] is pushed for 2 sec.
Push [MW] for 2 sec. after tuning.
[EXAMPLE]: Setting the frequency using the keypad.
USB
R X
USB
USB
R X
USB
R X
USB
R X
USB
R X
USB
R X
R X
USB
R X
USB
R X
USB
R X
USB
R X
USB
R X
USB
R X
USB
R X
USB
R X
1
5
JKL
8
TUV
.
.
.
0
QZ
5
JKL
8
TUV
USB
R X
0
QZ
•To set to 28.00 MHz
2
ABC
8
TUV
ENT
5
JKL
ENT
•To set to 21.050 MHz
2
ABC
•To set to 850 kHz (0.850 MHz)
ENT
ENT
•To change 14.19075 to 14.850 MHz