Nilfisk-advance Inc. ME401 Manuale Utente

Pagina di 24
 
ME401-9 
 
 
 
 
Nilfisk Advance ME401-9, Technical Manual v1.2, Marts 2014 
  Page 6 
Interference 
Like all wireless devices, the ME401-9 may encounter electrical interference that may 
affect its performance. 
 
Avoid Body Contact with Device during Operation 
Do not operate the ME401-9 in direct contact with your body. Maintain at least 2 inches (5 
cm) separation between the device and any parts of your body. 
 
Qualified Service 
Except for batteries and Subscriber Identification Module (SIM) card, the ME401-9 
contains no user serviceable or replaceable parts. Non-functioning units must be returned 
to an authorized service center for repair or replacement. 
 
Accessories and Batteries 
Use only approved accessories or batteries. Do not connect incompatible products. 
There is risk of explosion or fire if an incorrect type replacement battery contacts are 
shorted. Do not exceed the temperature ranges or other environmental conditions 
specified by the battery manufacturer. Dispose of used batteries according to the 
instructions provided with the batteries. 
 
Water-Resistance 
The ME401-9 series is water-resistant according to the IP-67 standard. It is however 
recommended that it is installed where it is relatively dry and not subjected to either water 
streams or submersion. 
 
 
 
Detailed Safety Information 
Exposure to Radio Frequency Signals 
The ME401-9 unit is a low power radio transmitter and receiver. Periodically the ME401-9 
wakes up either due to activity or by a timer. When it is ON (Awake), it receives and also 
sends out radio frequency (RF) signals for a short period of time. 
 
 
 
The ME401-9 unit is not designed to be worn on a person’s body.  
 
 
The ME401-9 unit cannot be turned off after installation; 
however the unit is mostly in standby waiting for activity 
on the acceleration sensor.  
With no external power the unit is OFF. In OFF mode a 
sleep timer secures a periodic wake up every hours until 
next activity on the acceleration sensor. 
 
The unit operation can continue for approximately 3 to 4 
days depending on the charging state of the backup 
battery.